Create IAS CIE coordinator and IAS Zone Door Sensor using Silicon Labs EmberZnet

The following steps show you how to create IAS CIE coordinator and IAS Zone Door Sensor using Silicon Labs EmberZnet 6.9.0 

1. Create and run IAS CIE coordinator for BRD4180A.

    1.1 Using the following steps to create CIE project for BRD4180A.

    1.2 Select "HA IAS Control and Indication Equipment" as ZCL device type, "Coordinator or Router" as Zigbee Device type, and enable  IAS Zone Client/Network Creator related plugin.

 

 

    1.3 Generate code to build firmware and download firmware into BRD4180A.

    1.4 Launch console and use CLI command "plugin network-creator form 1 0x5678 13 13" to form centralized Zigbee 3.0 network.

    1.5 Use CLI command "plugin network-creator-security open-network" to allow IAS Zone device to join.

2. Create and run IAS Zone Door Sensor device for BRD4161A.

    2.1 Using the following steps to create IAS Zone project for BRD4161A.

    2.2 Select "HA IAS Zone" as ZCL device type, "Sleepy End Device" as Zigbee Device type, use 0x0015 as zone type, enable "Security Sensor Interface" and "Network Creator..." related plugin.

 

    2.3 Add the following pin defines in hal-config.h to simulate PB1 on BRD4001A as reed switch of door sensor.

            #define GPIO_SENSOR_PIN                       (7U)
            #define GPIO_SENSOR_PORT                      (gpioPortF)

    2.4  Generate code to build firmware and download firmware into BRD4161A.

    2.5 Launch console and use CLI command "plugin network-steering start 0" to join centralized Zigbee 3.0 network that is formed and opened in step 1.4 and 1.5.

 

    2.5 In sniffer log, you would see the following event that show you IAS Zone sensor works with CIE. Press PB1 on BRD4001A would send IAS Zone status change notification.