The following steps show how Zigbee CIE and IAS device work: 1. ZC (act as CIE) enable permit join to allow IAS Zone device to join. ...

The following steps show you how to use two endpoints in SIMPLELINK-CC13X2-26X2-SDK Z-Stack zed_sw example. 1. Define a new SAMPLESW_E...

The following steps show you how to check APS ack in TI Z-Stack using ON/OFF cluster toggle command in SampleSwitch example. 1. Setup On...

660 Zigbee devices in the same Zigbee network now!!! This time, we have total 660 Zigbee devices, including 130 ZRs (Smart Plugs) and 53...

The following steps show you hot to build TI Z-Stack Linux Home Gateway reference design for x86 Linux. 1. Download Z-Stack_Linux_Gatewa...

Z-Stack uses the following formula to convert RSSI and LQI. LinkQuality = [255* (RSSI-MIN_ED)]/[MAX_ED-MIN_ED] Therefore with simple ...

The following steps show you how to use ZTool + Z-Stack 3.0 ZNP to set up Zigbee 3.0 network: 1. You have to prepare two CC253x EVBs (CC...

The following codes show example to create a periodic event that is triggered every 5 seconds for CC253x in Z-Stack and you can do it acco...

The following steps show how to use two UART ports in CC2530 Z-Stack 1. Define HAL_UART=TRUE, HAL_UART_ISR=1, and HAL_UART_DMA=2 in comp...

When a Zigbee device joins network, it would broadcast end node announcement with its short and IEEE address. We can register a callback e...

The following steps are used for cloning an existing Z-Stack coordinator. 1. Enable Compiler option MT_SYS_KEY_MANAGEMENT on coordinator...

The following steps show you how to use SensorTag CC2650STK with CC-DEVPACK-DEBUGGER as ZNP and connect to Z-Stack ZTool. 1. Revise the f...

Apply the following steps to SampleLight coordinator project and I can set the Logical Device type to Coordinator and router at run time. ...

The following steps show how to do device binding from TI Ztool and CC2531 USB dongle to CC2650 SensorTag using  ZDO_BIND_REQ. 1. Refer t...

The following steps show you how to setup Zigbee HA coordinator with TI Ztool and CC2531 USB dongle and use CC2650 SensorTag as Zigbee end ...

The following steps show you how to setup Zigbee HA coordinator with TI Ztool and CC2531 USB dongle and use CC2650 SensorTag as Zigbee end ...

The following codes are example to start PERIODIC_EVT every second and you can do any periodic processing in PERIODIC_EVT. //Put where...

This demonstration creates a Zigbee HA 1.2 network and adds 102 ZR and 6 ZED in to this demonstration system. The ZRs are smart plugs t...

Refer to CC253x/4x User's Guide . The following sample code can send PWM to P1_4.   PERCFG &= (~(0x20)); // Select Timer 3 Alter...

The battery monitor can also be used to do some simple temperature monitoring in CC2530. When the battery monitor is connected to the inter...